The review found that a cricial analysis of the epidemiology supported a qualitative association between occupational exposure to silica and obstructive lung function, but the data quality was not sufficient to calculate a quantitative relationship or define a threshold above which there was an increased risk.
Source: PubMed Abstract
The first meeting is April 24th; the new website is located here: L&I Website
One study was conducted in mice (Falcone et al., 2017), the other is a human epidemiology study (Wong et al., 2017). The exact agent responsible for the potential increase has not been identified.
Source: Falcone PubMed Abstract
Source: Wong PubMed Abstract
The top 3 are fall protection, accident prevention programs, and chemical hazard communication. The full list can be found at the link below:
Source: L&I
From NWCOHS: “This course will not only provide a useful framework for all safety managers but will illustrate lessons learned and best practices through a variety of case studies. This approach will demonstrate the utility of the risk assessment frame in safety management. Practical “in field” experiences will be shared that should allow the attendee to save time and point to effective approaches for daily work as well as for strategic planning.”
Source/Registration: NWCOHS
The full email from Josefina Magana is below:
“The Division of Occupational Safety and Health (DOSH) will be holding a Fall Protection Rulemaking stakeholder meeting on December 13, 2016, from 9:00 a.m. until 12:00 p.m. at the L&I Tukwila office located at 12806 Gateway Dr. S Tukwila, WA 98168 http://www.lni.wa.gov/Main/ContactInfo/OfficeLocations/tukwila.asp.
The purpose of this meeting is to go over the initial draft language for the proposed rule. Please RSVP if you wish to attend this meeting in order to ensure adequate room set-up.
If you wish to review any documents from prior meetings feel free to visit the following page:
http://www.lni.wa.gov/Safety/Rules/WhatsNew/FallProtection2016/default.asp
Thank you for your interest.”
Provides discussion points from the meeting, including the importance of defining “regulated area” and “competent person,” as well as comments that the intent of Washington’s standard is to mimic the OSHA standard. Comments on the proposed standard are due October 25th, 2016.
More information: Washington Labor & Industries
